In any tall building, the lateral forces is unarguably the most critical factor. Hence, fundamental to the design of any tall building is the lateral stability system.
Category: Structures
Timber joists are one of the most basic structural elements found in many timber frame construction. They are closely spaced timber beams (typically in the range of (450-900mm) used to support a suspended ceiling, timber flooring or sheathings. In this article, we shall discuss the design procedure of timber joist. All advice given will be based on the guidance and recommendations of BS EN 1993-1-1:2004 Eurocode 5 Design of Timber Structures- Part 1-1: General common rules of buildings.
The reading and interpretation of structural engineering drawings is a much-underrated skill. A skill that is often not taught but learnt through frequent exposure to structural engineering contents and a drive to fully understand them. In simple form, a structural drawing can be defined as any drawing consisting of plans or set of plans and details explicitly showing how a building or structure will be constructed
Many problems of long spanning in structural engineering can be resolved through the use of steel trusses. These days, long span structures are very popular– from sport arena roofs to auditorium galleries, airport terminals, railway stations etc….
The design of piled foundation unlike other foundation types largely falls within the remit of a geotechnical engineer with little assistance from the structural engineer. The first step requires the geotechnical team to conduct a detailed site investigation
For projects that requires deep foundations, the piles would be one of the first considerations at the concept design stage. The structural designer is expected to consider during the course of the project development, the type of piling that would be required, the proposed sizes
This article presents the design of cellular raft foundation, a spread foundation arrangement with two way interlocking ground beams with a ground bearing slab in contact with the soil and a suspended slab at the top surface…
Steel portal frames are the most common and cost-effective structural solutions for single-storey buildings with gable-pitched roofs. In fact, about 50% of the steelwork in the U.K is used up in the construction of single-storey buildings, of which portal frames form the greater part…
This article presents the design of concealed concrete beams, sometimes referred to as the “wide or strong band beams…
Unlike members in axial tension, when structural elements are subjected to axial compression, they become vulnerable to failure through instability as a result of their geometrical properties rather than their material properties…