Structures from first principles!
Foundation design has traditionally been conducted using the permissible stress method with the application of a global factor of safety. With the introduction of Eurocode 7, however, a distinctive design philosophy was presented, one that is based on the application partial factors. Thus, this article aims to investigate if higher bearing capacity values can be justified to Eurocode 7.
Retaining walls with respect to their form and construction method can be grouped into three categories vis a vis: gravity, embedded and hybrid. This is discussed in this article.
Ground improvement is the modification or treatment of weak and loose soil in order to improve their bearing capacities and potential settlement characteristics.
![[UPDATE] Foundation Types: Selecting a Foundation](https://structurescentre.com/wp-content/uploads/2021/06/121-330x288.jpg)
Selecting the most appropriate foundation type is often a very difficult undertaking in design and construction. Even, perhaps the most important part of the design process. Rightly so, it can be argued that the foundation of any structure is the most principal component of that structure
An inverted T beam foundation consist of an upstand ground beam embedded in a concrete slab, utilized to transmit a system of column loads safely to the ground (Figure 1).
This article discusses the reuse, and refurbishment strategies adopted for the Triton Square building in London to enable the addition of three extra floors. Increasing the total floor area by 70% while achieving a SCORS A rating for the overall carbon per unit area for the scheme.
A properly designed foundation must deliver these loads to the soil without overstressing the soil which could otherwise cause excessive settlement or shear failure of the bearing soil. In-order to avoid overstressing the soil geotechnical engineers and structural engineers must determine the bearing capacity of the soil upon which the structure is to be founded.
For projects that requires deep foundations, the piles would be one of the first considerations at the concept design stage. The structural designer is expected to consider during the course of the project development, the type of piling that would be required, the proposed sizes
Indeed, the significance of quality information and understanding of the soil conditions on a site can’t be understated.
Column base plates are provided beneath steel columns in order to transmit the applied design forces safely to the foundations. Steel columns are heavily loaded and their cross-sections are typically small…….